Ensure proper insertion of the bin each time, as Roomba will not run without it.
Brushes
Remove brush guard by lifting both yellow tabs.
Remove and clean the two brushes and brush bearings.
Use the included cleaning tool to remove hair easily from the bristle brush by pulling it over the brush.
Charging Contacts
Clean the charging contacts by wiping the charging contacts on the Home Base and robot with a clean, dry cloth.
Cliff Sensors
Simply wipe all six cliff sensor openings with a clean, dry cloth.
Filters
Remove the filter and shake off debris by tapping the filter against your rubbish bin as needed.
Do not expose the filters to water. This can cause damage to your robot and will void your warranty.
Front Caster Wheel
Front caster wheels that are clogged with hair and debris could result in floor damage. Use the following procedure to maintain the front caster wheel.
Pull firmly on the front wheel to remove it.
Remove any debris from inside the wheel cavity.
Remove the wheel from its housing and wipe clean. Pull firmly to remove the axle and clear any debris or hair wrapped around it.
Reinstall all parts when finished. Make sure the wheel clicks right back into place.
Full Bin Sensors
Remove the bin and wipe the two optical bin sensors with a clean, dry cloth.
Models 770 and above.
Side Brush
To clean the side brush, use a small Phillips screwdriver to remove the screw from the centre. Remove the brush, clean, reinstall.
Do not expose the filters to water. This can cause damage to your robot and will void your warranty.
