Roomba® 200/2000, How to Clean or Replace the Bin and Filter

How to Empty Bin

1. Press the DustCompactor™ bin release button to remove the bin.
   
   

2. Open door to empty and clean bin.

IMPORTANT: Do not rinse or soak the bin. Regularly clean bin to prevent dirt buildup.

3. Place the bin back in the robot.

IMPORTANT: Do not rinse or soak the bin. Regularly clean the bin to prevent dirt buildup.

How to Clean the Filter

1. Open bin door and remove filter. Remove the filter by grasping both ends while pinching the tab and pulling out.
   
   

2. Remove debris by tapping the filter against your trash container.
   
   

3. Wipe the bin with a clean cloth.

4. Reinsert filter with ridged grips facing out. Place bin back in the robot.

Note: The filter can be rinsed with water. Make sure it is completely dry before reinstalling. Frequent rinses are not recommended.

Cleaning the water tank (Combo models only)

1. Simultaneously press and hold both the release buttons of the water tank, and then slide it out from the bottom of the vacuum-mop as illustrated.
   
   

2. Empty out the old water, and rinse the tank with fresh water.

NOTE: If you use detergent to clean, use dish soap and be sure to rinse thoroughly before using again. Soap can damage the robot.

NOTE: After mopping, immediately remove the water tank, empty out any remaining water, and clean and dry the mop pad to prevent lingering odor and mildew.